Crash protection profile RSE
» Download product sheet (pdf)
Stainless steel crash protection profile Model RSE, welded, not flanged. Made of 2.0 mm metal plate, for wall mounting, 350 mm
high and 120 mm deep. With filling openings for subsequent mortar grouting. With inside wall anchors, upper edge inclined at an
angle less than 25°, incl. suspension rails made of AlMg3. Supplied lengths 3,000 – 6,000 mm. Ground grain surface 240.
Surface: Ground grain surface 240.
Grade: 1.4301 (AISI 304), 1.4571 (AISI 316 Ti)
Lid fill openings:
- welded and pickled
- welded and ground
- glued-in
Floor connection:
- lower connection as 45° fillet with vertical floor attachment 30 mm in the floor slot provided on site
- with tilt-back and floor attachment for floor slot and fillet to be provided on site
- with AlMg3 tilt-back and floor angle for fillet to be provided on site
- with AlMg3 tilt-back and floor angle for height adjustment for fillet to be provided on site
Inside corner
Inside corner for stainless steel crash protection profile Model RSE as mitre cut design. Weld seam pickled.
Outside corner
Inside corner for stainless steel crash protection profile Model RSE as mitre cut design. Weld seam pickled.
End piece
End piece for stainless steel crash protection profile Model RSE as welded cover plate. Weld seam pickled.
Drainage connection
Drainage connection as sleeve tube DN 50 for clean lead through building without any hygienically problematic places in the floor area.